According to the analysis of relevant technical parameters and applicable scenarios, the output of PCH1010 hammer crusher when processing coal is as follows:

1. Output range

Normal output: about 35-90 tons per hour (the specific value is affected by the characteristics of the raw materials).

Extreme working condition reference value: Under specific parameters (such as low moisture content, suitable particle size), the marked output can reach 10,000 kg/hour (i.e. 10 tons/hour), but this data may correspond to specific working conditions or unit marking differences, so please refer to it with caution.

2. Key influencing factors

Raw material moisture content: It needs to be controlled at <15%, otherwise it may cause blockage and production reduction.

Coal quality characteristics: It is suitable for medium-hard coal (such as bituminous coal and lignite) with compressive strength ≤100MPa. Too hard or high gangue content will reduce the output.

Particle size and feed uniformity: The feed particle size is ≤10mm and needs to be uniform and continuous, otherwise it will affect the crushing efficiency and production capacity.

3. Equipment adaptability description

PCH1010 is specially designed for coal crushing optimization. Its hammer structure can reduce over-crushing and improve the yield rate; however, the actual output needs to be comprehensively evaluated in combination with the production line configuration (such as feeder, screening equipment).

Summary:

Under the conditions of moderate coal quality (hardness ≤ 100MPa, moisture content < 15%) and uniform feeding, the reasonable output range of PCH1010 hammer crusher is 35-90 tons/hour, and it may be as low as 10 tons/hour under extreme working conditions. It is recommended to refer to the actual material test data for model selection.